Answered 24/7(833) 878-1592

Hydro Jetting OnlineHigh-pressure water. Cleaner pipes.
Call (833) 878-1592

Hydro Jetting in Montana

Montana is big, cold, and spread out, and its drains reflect all three. Winter lasts for months, frost goes deep, and a shallow line can freeze solid in January. The ground is often rocky, with thin soil over rock in the mountains and heavy clay in the valleys around Billings and Missoula. Homes sit on large lots, and a sewer line can run a long way from the house to the street, or to a septic tank where there is no city sewer at all. The housing is a mix of older homes in the city centers with cast iron still in the ground and newer building on the edges running PVC. Two Montana cities appear below, Billings and Missoula, each with its own page.

Winter, from the crew's side of the truck

A Montana jetting visit in January starts with digging. The cleanout may sit under two feet of snow, or under earth frozen hard as rock, and the crew has to open it before any jetting happens. The jetter itself keeps working: the water in the hose is always moving, and moving water does not ice up mid-job. What winter costs is time — time to find the cleanout, time to open it, time to work with cold hands.

Homeowners can buy that time back. Shovel a path to the cleanout before the crew arrives, and tell the booking person about the snow, so the crew brings what they need. When the outside way in is frozen shut, the crew works from inside the house, through a floor drain or a toilet pulled for the day. After the thaw, the lowest fixture in the house deserves a look — a wet patch or a new smell there can mean a joint gave way over the winter, and the camera will show it.

Distance changes everything

Montana is a big state with few people in it, and distance shapes every drain job. A plumber may drive an hour to reach a house. A sewer line on a large lot can run a long way from the house to the street, and a long run gives waste more places to settle and roots more joints to find. A problem halfway down the run will not show at the house until the line is well blocked.

On a long run the camera earns its keep, because it covers the full length of the line and pinpoints where the trouble sits — near the house, or near the street. Trees near the line are worth watching: a root that gets into a joint on a long run can travel a long way inside the pipe before it blocks it. Grease is the other enemy of a long run, since warm grease has time to cool and harden before it reaches the street or the tank.

Rock under a thin skin of soil

In the mountains, Montana soil is thin over rock, and a pipe laid through rocky ground can sit on a stone that presses on it for years. A stone pressing on a pipe can crack it or push a joint open, and the damage stays hidden until a fixture backs up. In the valleys around Billings and Missoula, the soil is heavy clay instead, which traps water against a pipe and swells in wet weather and shrinks in dry. Either way, the ground shifts a pipe over time.

The way to see what the ground has done is the camera. It shows the crack, the gap, the root hairs working through. The jetter shears the roots back and flushes the settled waste out. Water cannot fix a pipe the rock has cracked, and a straight crew says so when the footage shows one. For a Montana homeowner, that camera run settles the question before anyone starts digging.

Well water, and what it leaves behind

Montana water runs hard in many areas, and well water, common outside the cities, often runs harder still. Scale builds slowly on the inside of a pipe, and it grips rough cast iron far better than smooth PVC. The result is a line that narrows a little every year until a normal day of use — a shower and a load of laundry at once — is enough to back it up. In the older homes of Billings and Missoula, where cast iron is still in the ground, scale is a regular finding on camera.

Jetting takes scale off by throwing water at the pipe walls, and the flakes wash out with the flow. A badly scaled iron line may need two passes, and the crew should show you the camera footage before and after so you can see what came off. Where the scale is thick and the iron underneath is thin, the crew should ease off the pressure — the camera run beforehand is what spots that. Homes on well water deserve a camera look sooner rather than later, since well water usually carries a heavier mineral load than city water. A softener on the supply side slows new scale down, though it will not remove what is already there.

Two eras of Montana housing

Billings and Missoula both split the same way: older homes near the center, newer building on the edges. The older homes, many built before 1970, often still have cast iron and clay in the ground, put in when those materials were standard. Clay joints shift with the frost and let roots in. Cast iron scales up and rusts from the inside. The newer homes on the edges run PVC, and their trouble is grease from the kitchen and wipes that should never have been flushed.

House age is the fastest clue before the camera goes in. A pre-1970 home with slow drains probably has a material problem, not just a clog. A ten-year-old home with a backed-up kitchen line probably has a grease problem, and jetting clears it in one visit. Either way, ask for the camera first. It records what the line is made of and where its weak spots are, and that record is worth keeping when you sell the house.

When jetting is the wrong call

Jetting is not always the answer, and the camera is what says so. A belly — a dip where the ground has settled under a long run — will not stay clear: the jetting clears the waste out of the dip, but the dip stays, and the line collects waste again. A crack will not stay clear either: the jetting clears the line, but the crack stays, and roots come back through it. A collapsed section cannot be jetted at all.

In each case, the honest move is to stop after the camera run and talk about a repair, not to jet anyway and bill for it. Ask the crew to show you the footage and explain what they see. A company that jets a collapsed line without telling you is a company to think twice about. The jetting did its job in these cases too — by clearing everything else away, it proved where the real problem sits, and that proof is what a repair quote should be built on.

Cities in Montana

Hydro jetting pages for Montana are coming soon — 2 more cities are on the way. Call (833) 878-1592 to ask whether a local pro covers your area.

Services in Montana

Guides

Frequently asked questions

Get an estimate

Call for your estimate

Tell us what is happening and a local pro will take it from there. The call is free, and you agree on the price with the local company before any work starts.

(833) 878-1592How estimates work →

Lines answered 24/7.